Figure 51. Installing the M.2 SSD module on the M.2 riser
3. Using a Phillips #1 screwdriver, tighten the M.2 SSD module on the M.2 riser with the screw.
Next steps
1.
2. Follow the procedure listed in
After working inside your system
.
Linking board and PCIe cable
Removing the linking board and PCIe cable
Prerequisites
NOTE:
Observe the routing of the cable as you remove it from the sled. Route the cable properly when you replace it to
prevent the cable from being pinched or crimped.
●
Follow the safety guidelines listed in
.
●
Follow the procedure listed in
Before working inside your system
●
.
●
●
Steps
1. To disconnect the MB cable, press the release button on the MB_A cable connector and lift it. See
for more information.
2. Using a Phillips #2 screwdriver, loosen the captive screws that secure the linking board to the chassis.
Installing and removing system components
51
