Dell EMC VxFlex Ready Node R840, Manual

Page: 142 / 218

Table 13 Tasks for installing the replacement system board (continued)
Check
List Task Topic
☐ 4 Install the backplane cables, if applicable. See System board connectors on page
182.
☐ 5 Install the processor and heat sink
module. See Install the processor and heat sink
module on page 134.
☐ 6 Install the expansion card risers. See Install the expansion card risers on
page 106.
☐ 7 Install the cooling fan assembly. See Install the cooling fan assembly on
page 175.
☐
8 Install the air shroud. See Install the non-GPU air shroud on
page 169 or Install the GPU air shroud
on page 171.
☐
9 Replace the system cover. See Install the system cover on page
173.
☐
10 Slide the system into the cabinet. See Slide the system into the cabinet on
page 165.
☐
11 Connect the I/O cables and power cords. See Connect the I/O cables and power
cords on page 164.
☐ 12 Install the front bezel. See Install the front bezel on page 166.
☐ 13 Restore the service tag using easy
restore. See Restore the Service Tag by using the
Easy Restore feature on page 144. If the
Service Tag is not backed up in the
backup flash device, enter the Service
Tag manually. See
☐ 14 Install the Trusted Platform Module. See Install the Trusted Platform Module
on page 145.
☐ 15 If necessary, import your new or existing
iDRAC Enterprise license. For information, see the iDRAC User's
Guide
at https://dell.com/idracmanuals .
Perform mandatory software tasks to return the node to operation:
☐
16 Verify the new system board and return
the node to operation. See "Replacing the system board" in the
VxFlex Ready Node Field Replacement Unit
Software Guide
. Perform all software-
related tasks required after actual
replacing the system component,
according to the node's operating
system, starting with "Verify the new
system board in the node.
Remove the system board
Before you begin
Follow all safety guidelines.
Hardware FRU procedures
142 VxFlex Ready Node R840 Hardware Field Replacement Unit and Service Manual