Figure 21. Cable routing - 4 x 3.5-inch cabled SAS drive with storage controller card
Table 11. Connector descriptions for 4 x3.5-inch cabled SAS drive with storage controller card
From
To
ODD (Optical disc drive connector)
SATA_ODD (Optical disc drive SATA connector on system
board)
O HDD0, HDD1, HDD2, HDD3 (Optical disc drive
power connector, connecting through the drives 0, 1, 2, 3)
HDD/ODD_PWR (Drives/Optical disc drive power connector
on the system board)
HDD0, HDD1, HDD2, HDD3 (Signal connector connecting
through the drives 0, 1, 2, 3)
PERC (SAS connector of PERC card on the system board)
Optional optical drive
This is a service technician replaceable part only.
Removing the optical drive fillers
Prerequisites
1. Follow the safety guidelines listed in
.
2. Follow the procedure that is listed in
Before working inside your system
.
3.
.
NOTE:
There are two optical drive fillers, plastic filler on the front bezel, and metal filler on the optical drive cage.
Steps
1. On the front bezel, press the retention clip of the optical drive filler and pull the filler from the front bezel.
Installing and removing system components
35
