Installing the internal USB card
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in the
Before working inside your system
3.
.
Steps
1. Connect the USB key to the internal USB card.
2. Align the internal USB card with the connector on the system board and press firmly until the internal USB card is seated.
Figure 116. Installing the internal USB card
Next steps
1. Follow the procedure listed in
After working inside your system
.
2. While booting, press F2 to enter
System Setup
and verify that the system detects the USB memory key.
VGA module
This is a service technician replaceable part only.
Removing the VGA module
Prerequisites
1. Follow the safety guidelines listed in the
on page 25.
2. Follow the procedure listed in
Before working inside your system
3.
.
4.
5.
.
6. Disconnect the VGA cable from the VGA connector on the system board. For locating the connector, see the
Installing and removing system components
113