NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables
properly when you replace them to prevent the cables from being pinched or crimped.
1. Follow the safety guidelines listed in
on page 16.
2. Follow the procedure listed in
Before working inside your sled
on page 17.
3. Disconnect the cables connected to the backplane.
4.
5.
.
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the drive cage to the sled.
2. Lift the drive cage away from the sled.
Figure 40. Removing the drive cage
Next steps
1.
.
Installing the drive cage
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Before working inside the sled
.
Steps
1. Place the drive cage into the system, aligning with the screw holes on the system.
2. Using the Phillips #1 screwdriver, secure the drive cage in place with screws.
Installing and removing system components
37
