Dell E75S Series, Installation And Service Manual, Page: 89 / 133

2. Follow the procedure listed in the Before working inside your system .
3. Remove the air shroud .
4. Remove the drive backplane cover .
5. Remove the cooling fan cage assembly .
6. Disconnect the PERC cable from the system board connector, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
2. Pull the front PERC module to disengage from the connector on the drive backplane.
3. Llift the front PERC module out of the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 86. Removing the front mounting front PERC module
Next steps
1. Replace the front mounting front PERC module .
Installing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in the Before working inside your system .
3. Remove the air shroud .
4. Remove the drive backplane cover .
5. Remove the cooling fan cage assembly .
6. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align the front PERC module at an angle until the tray touches the slot in the system.
2. Press the front PERC module connector with the connector on the drive backplane until firmly seated.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
Installing and removing system components 89