Figure 61. Installing the network daughter card
Next steps
Follow the procedure listed in
After working inside your system
on page 24.
System battery
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the
manufacturer's instructions. See the safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in
on page 23.
2. Follow the procedure listed in
Before working inside your system
3.
Remove the expansion card riser 1
.
Steps
1. Locate the battery socket. For more information, see the
System board jumpers and connectors
section.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
2. Use a plastic scribe to pry out the system battery.
62
PowerEdge C4140 installing and removing system components
