NOTE:
The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module is provided for all system board replacements, where a TPM plug-in module was installed.
2. Replace the following:
a.
Replacing the optional internal USB memory key
on page 63
b.
Installing a processor and heat sink module
on page 59
c. Processors blanks (if applicable)
d.
on page 45
e.
Installing the expansion card risers
f. Installing PCH air shroud.
g.
on page 30
3. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
4. Follow the procedure listed in
After working inside your system
on page 24.
5. Ensure that you:
a. Use the Easy Restore feature to restore the Service Tag. For more information, see the
Restoring the system using Easy
section.
b. If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see
the
Manually update the Service Tag
section.
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). For more information, see the
Upgrading the Trusted Platform Module
section.
6. Import your new or existing iDRAC Enterprise license.
For more information, see
iDRAC User's Guide
, at
Restoring the system using Easy Restore
The easy restore feature enables you to restore your service tag, license, UEFI configuration, and the system configuration data
after replacing the system board. All data is backed up in a backup flash device automatically. If BIOS detects a new system
board, and the service tag in the backup flash device, BIOS prompts the user to restore the backup information.
About this task
Below is a list of options available:
●
Restore the service tag, license, and diagnostics information, press
Y
●
Navigate to the Lifecycle Controller based restore options, press
N.
●
Restore data from a previously created
Hardware Server Profile
, press
F10
NOTE:
When the restore process is complete, BIOS prompts to restore the system configuration data.
●
To restore the system configuration data, press
Y
●
To use the default configuration settings, press
N
NOTE:
After the restore process is complete, system reboots.
Manually update the Service Tag
After replacing a system board, if Easy Restore fails, follow this process to manually enter the Service Tag, using
System
Setup
.
About this task
If you know the system service tag, use the
System Setup
menu to enter the service tag.
Steps
1. Power on the system.
2. To enter the
System Setup
, press
F2
.
96
PowerEdge C4140 installing and removing system components
