2. Select iDRAC setting.
3. Select
Thermal
section.
4. Select
Fan Setup
setting.
5. At the
Fan Speed Offset
section, select
Low fan speed offset (+15%)
.
Optical drive
Removing the optical drive blank and filler
The optical drive blank is on the bezel and the optical drive filler is located in the optical drive slot on the hard drive cage.
Prerequisites
2. Follow the procedure listed in
Before working inside your system
3. Disconnect all peripherals connected to the control panel assembly.
4. Remove the bezel.
5. If connected, disconnect the power and data cable from the optical drive and hard drives.
6. Remove the hard drive cage.
Steps
1. On the bezel, press down on the retention clip of the optical drive blank and pull the blank out of the bezel.
Figure 27. Removing the optical drive blank from the bezel
1. bezel
2. retention clip
3. optical drive blank
4. optical drive blank locking tab (2)
2. On the hard drive cage, hold the tabs on the optical drive filler and remove the optical drive filler from the hard drive cage.
64
Installing and removing system components