Dell E36S Series, Owner'S Manual

Page: 43 / 120

Before working inside your system
Prerequisites
Ensure that you follow the Safety instructions on page 42.
Steps
1. Turn off the system and any attached peripherals.
2. Disconnect the system from the electrical outlet and disconnect the peripherals.
3. Lay the system on its side.
4. Remove the system cover.
Related tasks
Removing the system cover on page 43
After working inside your system
Steps
1. Install the system cover.
2. Place the system upright on its feet on a flat and stable surface.
3. Reconnect the peripherals and connect the system to the electrical outlet.
4. Turn on the system, including any attached peripherals.
Related tasks
Installing the system cover on page 44
Recommended tools
You need the following tools to perform the installation and removal procedures:
• Phillips #2 screwdriver
• Plastic scribe
• Wrist grounding strap connected to ground
System cover
The system cover protects the components inside the system and helps in maintaining air flow inside the system. Removing the system
cover activates the intrusion switch.
Removing the system cover
Prerequisites
1. Ensure that you follow the Safety instructions on page 42.
2. Turn off the system and any attached peripherals.
3. Disconnect the system from the electrical outlet and disconnect the peripherals.
4. Lay the system on its side.
Steps
Lift the cover release latch and remove the cover away from the system.
Installing and removing system components 43