Dell E30S Series, Owner'S Manual

Page: 66 / 194

Option Description
Load Legacy
Video Option
ROM
Enables you to determine whether the system BIOS loads the legacy video (INT 10H) option ROM from
the video controller. Selecting
Enabled
in the operating system does not support UEFI video output
standards. This field is available only for UEFI boot mode. You cannot set the option to
Enabled
if
UEFI
Secure Boot
mode is enabled.
In-System
Characterization
Enables or disables
In-System Characterization
. This option is set to
Disabled
by default. The two
other options are
Enabled
and
Enabled - No Reboot
.
NOTE:
The default setting for
In-System Characterization
is subject to change in future BIOS
releases.
When enabled, In-System Characterization (ISC) executes during POST upon detecting relevant changes
in system configuration to optimize system power and performance. ISC takes about 20 seconds to
execute, and system reset is needed for ISC results to be applied. The
Enabled - No Reboot
option
executes ISC and continues without applying ISC results until the next time system reset occurs. The
Enabled
option executes ISC and forces an immediate system reset so that ISC results can be applied.
It takes the system longer to be ready due to the forced system reset. When disabled, ISC does not
execute.
Related references
Miscellaneous Settings on page 65
Related tasks
Viewing Miscellaneous Settings on page 65
iDRAC Settings utility
The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable
various iDRAC parameters by using the iDRAC settings utility.
NOTE:
Accessing some of the features on the iDRAC settings utility needs the iDRAC Enterprise License upgrade.
For more information about using iDRAC, see
Dell Integrated Dell Remote Access Controller User's Guide
at Dell.com/
idracmanuals .
Related concepts
Device Settings on page 67
Related references
System BIOS on page 42
Related tasks
Entering the iDRAC Settings utility on page 66
Changing the thermal settings on page 67
Entering the iDRAC Settings utility
Steps
1. Turn on or restart the managed system.
2. Press F2 during Power-on Self-test (POST).
3. On the
System Setup Main Menu
page, click
iDRAC Settings
.
The
iDRAC Settings
screen is displayed.
Related references
iDRAC Settings utility on page 66
66 Pre-operating system management applications