3
Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the memory module
in the socket.
CAUTION:
Do not apply pressure at the center of the memory module; apply pressure at both ends of the memory module
evenly.
NOTE:
The memory module socket has an alignment key that enables you to install the memory module in the socket in only
one orientation.
4
Press the memory module with your thumbs until the socket levers firmly click into place.
When the memory module is properly seated in the socket, the levers on the memory module socket align with the levers on the other
sockets that have memory modules installed.
Figure 19. Installing the memory module
1
memory module
2
alignment key
3
memory module socket ejector (2)
Related links
Safety instructions
System Setup
Before working inside your system
Removing the cooling shroud
Removing the internal PERC riser
Installing the internal PERC riser
Installing the cooling shroud
After working inside your system
Using system diagnostics
Hard drives
Your system supports up to twelve 3.5 inch or 2.5 inch (with 3.5 inch drive carrier adapters) hot-swappable hard drives/SSDs and two
internal 2.5 inch cabled hard drives/SSDs.
Hard drives that connect to the system board through the hard drive backplane are hot-swappable. Hot-swappable hard drives are supplied
in hot-swappable hard drive carriers that fit in the hard drive slots. The internal cabled hard drives/SSDs are not hot-swappable.
68
Installing and removing system components
