Removing the internal PERC riser
Prerequisites
1
Follow the safety guidelines listed in the Safety instructions section.
2
Follow the procedure listed in the Before working inside your system section.
3
If connected, disconnect the cables from the expansion card(s).
4
If required, remove the dual riser module.
5
Remove the cooling shroud.
Step
Hold the internal PERC riser module by the edges and lift it out of the system.
Figure 41. Removing the internal PERC riser
1
internal PERC riser module
2
guide slot on the internal PERC riser (2)
3
internal PERC riser
4
guide pin on the chassis (2)
5
PCIe connector on system board
Next steps
1
Install the cooling shroud.
2
If removed, reinstall the dual riser module.
3
Reconnect all disconnected cables.
4
If required, open the expansion card latch on the cooling shroud to support the full length expansion card.
Installing and removing system components
97
