Figure 68. Removing the control panel module—eight hard drive chassis
a. control panel module
b. screw (2)
c. control panel module connector cable
Related tasks
Before working inside your system
Installing the control panel module
Related reference
Installing the control panel module
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Insert the control panel module into the slot in the chassis and align the two screw holes on the control panel module with the
corresponding holes on the chassis.
2. Secure the control panel module with the screws.
3. Connect all the applicable cables to the control panel module.
112
Installing and removing system components
