Clearing CMOS Settings
1.
Follow the procedures in "
Before You Begin
."
2.
Reset the current CMOS settings:
a.
Locate the 3-pin CMOS jumper (RTCRST) on the
system board
.
b.
Remove the jumper plug from pins 2 and 3.
c.
Place the jumper plug on pins 1 and 2 and wait for approximately 5 seconds.
d.
Replace the jumper plug on pins 2 and 3.
3.
Close the
computer cover
.
4.
Connect your computer and devices
Back to Contents Page
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide
.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.