4-18
Dell PowerEdge 2200 Systems Service Manual
5. Remove the system board assembly from the chassis as follows:
a. Slide the system board assembly about a half-inch toward the front of
the computer to free the assembly from the tabs (see Figure 4-18).
Figure 4-18. Removing the System Board Assembly From
the Chassis
b. Raise the top of the system board assembly up enough to allow access to
the system board cables.
c. Disconnect the power cables, control panel cable, diskette drive inter-
face cable, hard-disk drive access indicator cable, system cooling-fan
cables, and SCSI interface cable.
6. Lift the system board assembly away from the computer chassis.
Microprocessor Module
To remove a microprocessor module, follow these steps:
1. Write down or print out the system configuration information in the
EISA Configuration Utility.
2. Remove the system board assembly.
3. Remove the microprocessor module.
a. Remove the two screws securing the microprocessor module (see
Figure 4-19).
WARNING: The microprocessor module can get extremely hot dur-
ing system operations. Be sure it has had sufficient time to cool
before touching it.
front of computer
system-board
mounting plate
tabs (2)