5.
Ground yourself and install the new memory module:
a.
Align the notch in the module connector with the tab in the connector slot.
b.
Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove
the module and reinstall it.
DIMM B
1.
Follow the procedures in
Before You Begin
.
2.
Turn the computer bottom-side up, loosen the captive screw in the memory module cover, and then remove the cover.
3.
If you are replacing a memory module, ground yourself and remove the existing module:
a.
Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
b.
Remove the module from the connector.
1
securing clips (2 per connector)
2
memory module
NOTE:
If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.
NOTICE:
If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMMA" before you install a
module in the connector labeled "DIMMB." Insert memory modules at a 45-degree angle to avoid damaging the connector.
1
memory module cover
2
captive screw
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the memory-module securing clips.
Summary of Contents for D620 - Latitude Laptop Computer System Core Duo Processor Wireless XP Pro
Page 3: ......
Page 17: ...Back to Contents Page ...
Page 21: ...Back to Contents Page 1 keyboard 2 system board connector ...
