Steps
1. Align and replace the interposer module on the system board.
2. Replace the single screw (M3x5) and connect the SATA cable to the connector on the system board and close the actuator.
Next steps
1. Install the
.
2. Install the
NOTE:
This step is valid for system configuration that is shipped with 80 W CPU.
3. Install the
4. Install the
5. Install the
.
6. Follow the procedure in
after working inside your computer
.
Processor
Removing the processor
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
3. Remove the
.
4. Remove the
.
5. Remove the
.
6. Remove the
About this task
The following images indicate the location of the processor and provide a visual representation of the removal procedure.
Demonteren en hermonteren
61
Summary of Contents for D16S
