Installing the system board
1
Align the system board with the screw holders on the computer.
2
Tighten the M2xL3 screws to secure the system board to the computer.
3
Route the speaker through the cable guide and connect the speaker cable to the its connector.
4
Affix the adhesive of the audio board cable to the system board and connect the audio board cable to its connector.
5
Connect the <engineering input> cable to its connector on the system board.
6
Replace the metal retaining bracket and tighten the screw to secure it to the system board.
7
Connect the display assembly cable to its connector.
8
Place the metal bracket on the display cable connector and tighten the screw.
9
Connect the keyboard and touchpad cables to their connectors on the system board.
10 Connect the antenna cables to the WLAN card.
11 Install the:
a
b
c
d
12 Follow the procedure in
After working inside your computer
.
Display assembly
Removing the display assembly
1
Follow the procedure in
Before working inside your computer
.
CAUTION:
The touch LCD Assembly is pre-assembled with the LCD bezel, touch sensor daughter board, touch sensor
cable, display cable, and the camera module and hence cannot be further torn down and must be replaced as an
assembly.
2
Remove the:
a
b
c
3
Then:
a Disconnect the eDP cable [1].
b Disconnect the antenna cables from the WLAN card [2].
c Unroute the WLAN cable from the its routing guide on the fan [3].
d Remove the M1.6xL2 screw securing the power port to the display hinge [4].
e Remove the power port from the system board [5].
Removing and installing components
23
Summary of Contents for Chromebook 11 3380
Page 44: ...44 Software ...
