Dell C9000 series, Reference Manual

Page: 710 / 2286

dcbx version
Configure the DCBX version used on the interface.
C9000 Series
Syntax
dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBX version, use the
no dcbx version
command.
Parameters
auto | cee | cin |
ieee-v2.5 Enter the DCBX version type used on the interface, where:
•
auto
: configures the port to operate using the DCBX
version received from a peer.
•
cee
: configures the port to use CDD (Intel 1.01).
•
cin
: configures the port to use Cisco-Intel-Nuova (DCBX
1.0).
•
ieee-v2
: configures the port to use IEEE 802.1az (Draft
2.5).
Defaults Auto
Command Modes INTERFACE PROTOCOL LLDP
Command History This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9 (0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Data Center Bridging (DCB) 710