Dell C9000 series, Reference Manual

Page: 2280 / 2286

Related
Commands vlan-stack compatible — enables stackable VLAN on a VLAN.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
C9000 Series
Syntax
vlan-stack access
To remove access port designation, use the
no vlan-stack access
command.
Defaults Not configured.
Command Modes INTERFACE
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
Usage Information Prior to enabling this command, to place the interface in Layer 2 mode, enter the
switchport
command.
To remove the access port designation, remove the port (using the
no member
interface
command) from all stackable VLAN enabled VLANs.
VLAN Stacking 2280