Dell C9000 series, Reference Manual

Page: 2116 / 2286

Usage Information STP is not enabled when you enter SPANNING TREE mode. To enable STP globally on
the switch, use the
no disable
command from SPANNING TREE mode.
Example
Dell(conf)#protocol spanning-tree 0
Dell(config-stp)#
Related
Commands disable — disables spanning tree group 0. To enable spanning tree group 0, use the
no
disable
command.
show config
Display the current configuration for the mode. Only non-default values display.
C9000 Series
Syntax
show config
Command Modes SPANNING TREE
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(config-stp)#show config
protocol spanning-tree 0
no disable
Dell(config-stp)#
Spanning Tree Protocol (STP) 2116