Dell C9000 series, Reference Manual, Page: 1894 / 2286

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information If you want the interface to receive both versions of RIP, use the
ip rip receive
version 1 2
command.
Related
Commands
ip rip send version — sets the RIP version for sending RIP traffic on an interface.
version — sets the RIP version the switch software uses.
ip rip send version
To send a specific version of RIP, set the interface. The version you set on the interface overrides the version
command in ROUTER RIP mode.
C9000 Series
Syntax
ip rip send version [1] [2]
To return to the default value, use the
no ip rip send version
command.
Parameters
1 (OPTIONAL) Enter the number
1
for RIP version 1. The default is
RIPv1.
2 (OPTIONAL) Enter the number
2
for RIP version 2.
Defaults RIPv1
Command Modes INTERFACE
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Routing Information Protocol (RIP) 1894