Dell C9000 series, Reference Manual

Page: 1131 / 2286

Version Description
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
E-Series legacy
command
ip igmp querier-timeout
Change the interval that must pass before a multicast router decides that there is no longer another multicast
router that should be the querier.
C9000 Series
Syntax
ip igmp querier-timeout seconds
To return to the default value, use the
no ip igmp querier-timeout
command.
Parameters
seconds Enter the number of seconds the router must wait to become
the new querier. The range is from 60 to 300. The default is
125
seconds .
Defaults 125 seconds
Command Modes INTERFACE
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Internet Group Management Protocol (IGMP) 1131