9
Brocade VDX 6940 Switch Configuration Guide for Dell PS Series SANs | SCG3306
2.11
Enable link level flow control (802.3x)
sw0(conf-if-te-1/0/1:1-4)#
qos flowcontrol tx off rx on
sw0(conf-if-te-1/0/1:1-4)#
exit
Reminder:
Perform these steps on the other 4 x 10 edge ports.
2.12
Configure spanning tree on edge ports
sw0(config)#
protocol spanning-tree rstp
sw0(config-rstp)#
exit
sw0(config)#
interface TenGigabitEthernet 1/0/1:1-4
sw0(conf-if-te-1/0/1:1-4)#
spanning-tree edgeport
Reminder:
Perform these steps on the other 4 x 10 edge ports.
2.13
Disable LLDP iSCSI priority on switch ports
sw0(conf-if-te-1/0/1:1-4)#
no lldp disable
sw0(conf-if-te-1/0/1:1-4)#
no cee
sw0(conf-if-te-1/0/1:1-4)#
no lldp iscsi-priority
sw0(conf-if-te-1/0/1:1-4)#
end
Reminder:
Perform these steps on the other 4 x 10 edge ports.
2.14
Save configuration
Sw0#
copy running-config startup-config
This operation will modify your startup configuration. Do you want to continue?
[y/n]:
y
2.15
Configure additional switch
Repeat the commands from sections 2.1 through 2.14 to configure the second switch.
