3. Lift the intrusion switch module out of the system.
Figure 32. Removing the intrusion switch module
Next steps
Replace the intrusion switch module
.
Installing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3.
.
4. Disconnect the system power cable from the system board.
Steps
1. Align and insert the intrusion switch module into the slot on the system until firmly seated.
2. Using the Phillips #1 screwdriver, tighten the screw securing the intrusion switch module.
3. Connect the intrusion switch cable to the connector on the system board.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
44
Installing and removing system components
Summary of Contents for 8TTX3
Page 16: ...Figure 10 Service information 16 System overview ...
Page 17: ...Figure 11 Service information System overview 17 ...
Page 18: ...Figure 12 Memory information Figure 13 Configuration and layout 18 System overview ...
Page 19: ...Figure 14 Configuration and layout Figure 15 LED behavior System overview 19 ...
