Figure 70. Installing the BOSS S2 card carrier
Next steps
1. Connect the BOSS S2 power and signal cables to the connectors on the BOSS S2 module and system board.
NOTE:
Insert the BOSS S2 power and signal cable through the cable clip.
2. Follow the procedure listed in the
After working inside your system
.
3.
.
Optional IDSDM module
Removing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3.
.
4. If you are replacing the IDSDM card, remove the MicroSD cards.
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
Holding the pull tab, lift the IDSDM card out of the system.
Installing and removing system components
81
