Steps
1. Align and place the coin-cell battery into its slot on the palm-rest and keyboard assembly.
2. Connect the coin-cell battery cable to the connector on the system board.
Next steps
1. Install the
or the
, whichever applicable.
2. Install the
.
After working inside your computer
.
Display assembly
Removing the display assembly
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
or the
, whichever applicable.
About this task
NOTE:
The display assembly removal procedure is the same for both clamshell and 2-in-1 convertible chassis.
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Removing and installing components
35
Summary of Contents for 3330
