3-2
Dell Inspiron Systems Setup Guide
To connect the printer to the computer, perform the following steps:
1.
Turn off the computer and make sure that the printer is also turned off.
2.
Attach the printer cable to the parallel connector on the computer and the printer.
Secure the printer cable connector to the computer connector by tightening the
two screws (see Figure 3-1). Secure the printer cable connector to the printer
connector by snapping the two clips into the two notches.
3.
Turn on the printer and then turn on the computer.
NOTE: If the
Add New Hardware Wizard
screen appears, click
Cancel
.
4.
Go to “Installing Software for a Printer,” found later in this chapter.
+*
NOTE: USB devices can be connected to the computer while it is on.
To connect the printer to the computer, perform the following steps:
1.
Attach the printer cable to the USB connector on the computer and the printer.
The USB connectors are keyed to fit only one way.
An example of a typical USB printer setup is shown in Figure 3-2.
parallel printer
cable
parallel connector
on computer
parallel connector
on printer
screw (2)
clip (2)
notch (2)
