Dell 13 7000 2-in-1, Service Manual

Page: 51 / 95

Removing the system board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before
working inside your computer . After working inside your computer, follow
the instructions in After working inside your computer . For more safety best
practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance .
NOTE: Your computer’s Service Tag is stored in the system board. You must
enter the Service Tag in the BIOS setup program after you replace the
system board.
NOTE: Replacing the system board removes any changes you have made to
the BIOS using the BIOS setup program. You must make the appropriate
changes again after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note the
location of the connectors so that you can reconnect the cables correctly
after you replace the system board.
Prerequisites
1 Remove the base cover .
2 Remove the battery .
3 Remove the solid-state drive .
4 Remove the heat sink .
Procedure
1 Peel the adhesive tape that cover the display cable and touchscreen-board cable
connectors on the system board.
2 Open the latches and disconnect the display cable and touchscreen-board cable
from the system board.
3 Disconnect the power-adapter port cable from the system board.
4 Peel the adhesive tape that secures the latch on the I/O-board cable connector.
51