步驟
1. Slide in and align the vFlash media unit with the vFlash media slot on the back of the chassis.
2. Connect the cable to the vFlash media unit.
3. Replace the screw securing the vFlash media unit to the chassis.
後續步驟
Complete the tasks listed in After working inside your system section in this document.
相關工作
Before working inside your system
After working inside your system
相關參考
Integrated storage controller card
Your system includes a dedicated expansion card slot on the system board for an integrated storage controller card. The integrated
storage controller card provides the integrated storage subsystem for the internal hard drives in your system. The controller supports SAS
and SATA hard drives and also enables you to set up the hard drives in RAID configurations. The RAID configurations depend on the
version of the storage controller included with your system.
Removing integrated storage controller card
事前準備作業
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
4. Remove the expansion-card riser 1.
5. Keep the #2 Phillips screwdriver handy.
警示
:
許多維修僅可由獲得認可的維修技術人員來完成。
您
只能依照
產
品說明文件中的授權說明或在線上或電話服務和支援團隊
的指導下，執行故障排除和簡單的維修。由未經
Dell
授權的維修造成的損壞不在保固範圍之內。請閱讀並遵循隨
產
品寄送的安
全指示。
步驟
1. Loosen the screws that secure the integrated storage controller cable to the integrated storage-controller card connector on the
system board.
2. Lift out the integrated storage controller cable.
3. Lift one end of the card and angle it to disengage the card from the integrated storage-controller card holder on system board.
4. Lift the card out of the chassis.
80
Installing and removing system components
