●
Optional: The equipment rack is properly mounted and grounded.
●
The ambient temperature around the platform, which may be higher than the room temperature, is within the limits that are
specified for the Edge 600 Series. For more information, see
.
●
There is no source of heat near the unit.
NOTE:
ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap
when handling the platform and components.
Start up sequence
When the platform powers up, the fans immediately come on at high speed. The fan speed slows as the platform continues to
boot.
Platform setup
About this task
WARNING:
To avoid electrostatic discharge (ESD) damage, wear grounding wrist straps when handling this
equipment.
Install the device in an area that meets the following safety requirements:
●
Use a properly grounded AC power outlet.
●
In a temperature-controlled room with a temperature range from 0°C to 40°C (32°F to 104°F).
●
In a dry, clean, and well-ventilated room away from heat sources such as hot air vents or direct sunlight
●
Away from severe electromagnetic noise
The numbers one through four in the following figure correspond to the setup procedure:
Figure 10. Illustration of the Edge 600 series Installation
Steps
1. Connect the DC power connector on the power adapter to the power port and tighten the lock-nut on the power plug.
Edge 600 Series installation
19