WARNING:
When no cable is connected, visible and invisible laser radiation may be
emitted from the aperture of the optical transceiver ports. Avoid exposure to laser
radiation and do not stare into open apertures.
Install the device in an area that meets the following safety requirements:
•
Near a properly grounded AC power outlet.
•
In a temperature-controlled room with a continuous temperature range from 0°C to
40°C (32°F to 104°F)
•
In a dry, clean, and well-ventilated room away from heat sources such as hot air vents or
direct sunlight
•
Away from severe electromagnetic noise
•
Away from direct view within the workplace
The numbers one through four in the following figure correspond to the setup procedure:
1
Connect the power adapter to the AC power outlet. Connect the other end of the
power adapter to the power port on the Edge. When the Edge powers ON, verify that
the status LED on the front of the Edge is on.
NOTE:
Connect the device to a properly wired earth-ground AC power
outlet.
2
Connect one of the default WAN ports (GE3-6 or SFP1-2) to an available Internet
connection. SFP modules are not included.
Edge 600 Series
5
