Management ports
Besides the 10/100/1000Base-T RJ-45 ports, the S5048F-ON switch provides several ports for management and storage.
NOTE:
The output examples in this section are for reference only. Your output may vary.
Topics:
•
•
MicroUSB-B console port access
•
•
•
•
RS-232 console port access
The RS-232 console port is on the I/O-side of the S5048F-ON switch.
Figure 18. S5048F-ON switch RS-232 console and management ports
1
Top: RJ-45 management port. Bottom: RS-232 serial console port.
CAUTION:
Ensure that any equipment attached to the serial port can support the required 115200 baud rate.
NOTE:
Before starting this procedure, ensure that your PC has a 9-pin serial port and that you have installed a terminal emulation
program on the PC.
NOTE:
If your PC’s serial port cannot accept a female DB-9 connector, use a DB-9 male-to-male adaptor.
1
Install the provided RJ-45 connector-side of the provided cable into the switch console port.
2
Install the DB-9 female-side of the provided copper cable into your PC’s serial port. Or install the DB-9 cable into other data terminal
equipment (DTE) server hardware.
3
Keep the default terminal settings on the console as follows:
•
115200 baud rate
•
No parity
•
8 data bits
•
1 stop bit
7
34
Management ports
