3.
4.
.
Steps
1. Disconnect and remove the intrusion switch cable from the connector on the system board.
Observe the routing of the cable as you remove it from the chassis.
2. Remove the screws securing the switch bracket and move it away from the chassis.
3. Remove the intrusion switch from the chassis.
Figure 73. Front intrusion switch removal
Next steps
Replace the front intrusion switch
.
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in the
Before working inside your system
3.
4.
.
Steps
1. Align and insert the intrusion switch in the slot until it is firmly seated in the slot on the system.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
2. Replace the screws to secure the switch bracket to the chassis.
3. Connect the intrusion switch cable to the connector on the system board.
Installing and removing enclosure components
67
