Figure 50. Installing a 3.5-inch drive adapter into the 3.5-inch drive carrier
Next steps
1
Install the 3.5-inch drive carrier into the system
.
2
If removed,
.
Drive backplane bracket
Removing the drive bay 1 backplane bracket
Prerequisites
NOTE:
Ensure that the drive bay 1 and 2 is in open position to access the backplane bracket.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system.
3
If installed,
.
4
Remove all the drives from drive bay 1.
5
Steps
1
Using a Phillips #1 screwdriver, remove the screws on top of the drive bay 1.
2
Slide the bracket to the right to disengage it from the slots at the bay base in drive bay 1.
3
Lift the bracket away from the system.
78
Installing and removing system components
