Figure 74. Installing a memory module
Next steps
1
2
Install
3
Place the system into the rack. For more information, see the Rail Installation Guide available at
.
4
, install
5
Install the
6
Follow the procedure listed in
After working inside your system
.
7
To verify if the memory module has been installed properly, press F2 and navigate to
System Setup Main Menu > System BIOS >
Memory Settings
. In the
Memory Settings
screen, the System Memory Size must reflect the updated capacity of the installed
memory.
8
If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module is firmly
seated in the memory module socket.
9
Run the system memory test in system diagnostics.
Processor and heat sink
Removing a processor and heat sink module
Prerequisites
WARNING:
The heat sink may remain hot to touch for some time after the system is powered down. Allow the heat sink to cool
before removing it.
1
Follow the safety guidelines listed in
2
Power off the system and all attached peripherals.
3
Disconnect the system from the electrical outlet, and disconnect the peripherals.
4
, remove
5
Remove the
.
6
Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
.
7
.
Installing and removing system components
103
