Figure 60. Installing the heat sink onto the processor
Next steps
1
Install the processor and heat sink module
.
2
Follow the procedure listed in the
After working inside your sled
section.
Installing the processor and heat sink module
Prerequisites
CAUTION:
Never remove the heat sink from a processor unless you intend to replace the processor. The heat sink is necessary to
maintain proper thermal conditions.
1
Follow the safety guidelines listed in the
section.
2
Follow the procedure listed in the
Before working inside your sled
section.
3
If installed, remove the processor dust cover.
Steps
1
Align the pin 1 indicator of the heat sink to the system board or PEM and then place the processor and heat sink module (PHM) on
the processor socket.
CAUTION:
To avoid damaging the fins on the heat sink, do not press down on the heat sink
fins.
NOTE:
Ensure that the PHM is held parallel to the system board or PEM to prevent damaging the components.
2
Push the blue retention clips inward to allow the heat sink to drop into place.
3
Using the Torx #T30 screwdriver, tighten the screws on the heat sink in the order below:
a Partially tighten the first screw (approximately 3 turns).
Installing and removing sled components
93
