Figure 8. Removing a sled from the enclosure
Next steps
Replace the sled into the enclosure
or sled blank.
Installing the sled into the enclosure
Prerequisites
1. Follow the safety instructions listed in
on page 14.
2. Remove the blank if installed.
3. Remove the I/O connector cover from the sled, if installed.
CAUTION:
To prevent damage to the I/O connectors, do not touch the connectors or the connector pins.
Steps
1. Hold and slide the sled into the enclosure.
2. Lock the sled removal handle to ensure that sled is firmly seated into the enclosure.
16
Installing and removing system components
