Steps
1. Align the notch on the solid-state drive with the tab on the SSD2 slot.
2. Slide the solid-state drive into the SSD2 slot.
3. Using the guide post, place the solid-state drive thermal bracket over the solid-state drive.
4. Align the screw hole on the solid-state drive thermal bracket with the screw hole on the system board.
5. Replace the screw (M2x4) that secures the solid-state drive thermal bracket and the solid-state drive to the system board.
6. Adhere the tape that secures the solid-state drive thermal bracket to the system board.
Next steps
1. Install the
2. Install the
.
3. Follow the procedure in
After working inside your computer
.
Fans
Removing the fan 1
Prerequisites
1. Follow the procedure in
Before working inside your computer
.
2. Remove the
About this task
The following image indicates the location of the right fan 1 and provides a visual representation of the removal procedure.
NOTE:
Fan depicted is for systems with discrete graphics, UMA fan may appear different but installs in the same
manner.
Disassembly and reassembly
29
Summary of Contents for P92F
Page 40: ...40 Disassembly and reassembly ...
Page 42: ...42 Disassembly and reassembly ...
Page 48: ...48 Disassembly and reassembly ...
