Steps
1. Align the screw hole on each solid-state drive thermal bracket with the respective screw hole on the palm-rest and keyboard
assembly.
2. Align the screw holes on the battery with the screw holes on the solid-state thermal brackets and the palm-rest and keyboard
assembly.
NOTE:
The two screws (M2x4) that secure the top of the battery also secure the solid-state drive thermal brackets
to the system board. Ensure that the solid-state drive thermal bracket is installed between the battery and the
system board.
3. Replace the two screws (M2x4) that secure the top of the battery and the solid-state drive thermal brackets to the palm-rest and
keyboard assembly.
4. Replace the five screws (M2x4) that secure the bottom of the battery to the palm-rest and keyboard assembly.
5. Connect the battery cable to the system board.
Next steps
1. Install the
.
2. Follow the procedure in
After working inside your computer
.
Memory modules
Removing the memory modules
Prerequisites
1. Follow the procedure in
Before working inside your computer
.
2. Remove the
About this task
The following image indicates the location of the memory modules and provides a visual representation of the removal procedure.
Disassembly and reassembly
19
Summary of Contents for P92F
Page 40: ...40 Disassembly and reassembly ...
Page 42: ...42 Disassembly and reassembly ...
Page 48: ...48 Disassembly and reassembly ...
