Procedure
1. Remove rails and hardware from packaging.
2. Verify that all components are included.
3. Locate the inner and outer rails and secure the inner rail to the outer rail.
4. Attach the rails assembly to the rack using the eight screws as illustrated in the
following figure.
Note:
The rail assembly is adjustable for NEMA, front to rear spacing
extends from 22 in to 34 in.
Figure 1 Install the inner rail to the outer rail
5. Attach the switch rails to the switch by placing the larger side of the mounting
holes on the inner rail over the shoulder studs on the switch. Press the rail even
against the switch.
Note:
The orientation of the rail tabs for the front NEMA rail are located on
the power supply side of the switch.
Figure 2 Install the inner rails
6. Slide the inner rail towards the rear of the switch slide into the smaller side of
each of the mounting holes on the inner rail. Ensure the inner rail is firmly in
place.
7. Secure the switch to the rail, securing the bezel clip and switch to the rack
using the two screws as illustrated in the following figure.
Install new Generation 6 hardware
Generation 6 Installation Guide 0
11
