NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
4. Using the Phillips #1 screwdriver, tighten the screws to secure the left control panel to the system.
Figure 24. Installing the left control panel
Next steps
1.
Install the drive backplane cover
.
3. Follow the procedure listed in
After working inside your system
on page 26.
VGA module
Removing the VGA module
Prerequisites
1. Follow the safety guidelines listed in the
on page 25.
2. Follow the procedure listed in the
Before working inside your system
3. If installed,
.
4.
5. If installed,
6. Disconnect the VGA cable from the connector on the system board and open the cable latch.
7. Disconnect the right control panel cable from the system board and move it away to see the VGA module screw on the
system.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Installing and removing system components
35
