d. To test the newly installed battery, remove the system from the enclosure for at least an hour.
e. Reinstall the system into the enclosure after an hour.
f. Enter the System Setup and if the time and date are still incorrect, see Getting help section.
Optional internal USB card
NOTE:
To locate the internal USB port on the system board, see the
System board jumpers and connectors
section.
Removing the internal USB card
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in the
on page 25.
2. Follow the procedure listed in the
Before working inside your system
3.
Remove the expansion card risers
Steps
1. Holding the blue tag, lift the internal USB card to disconnect from the connector on the system board.
2. Remove the USB memory key from the internal USB card.
Figure 112. Removing the internal USB card
Next steps
1.
.
Installing the internal USB card
Prerequisites
1. Follow the safety guidelines listed in the
on page 25.
2. Follow the procedure listed in
Before working inside your system
Installing and removing system components
111
