Dell EMC E46S001, Installation And Service Manual, Page: 134 / 184

Installing the M.2 SSD module
Prerequisites
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in Before working inside your system .
3 Remove the air shroud .
4 Remove the BOSS card
NOTE: The procedure to remove the BOSS card is similar to the removing an expansion card .
Steps
1 Connect the M.2 SSD module to the connector on the BOSS card.
2 Place the retention strap on the M.2 SSD module, and tighten the screw to secure the module.
Figure 90. Installing the M.2 SSD module
Next steps
1 Install the BOSS card.
NOTE: The procedure to install the BOSS card is similar to the Installing expansion card on the system board .
2 Install the applicable air shroud .
3 Follow the procedure listed in After working inside your system .
134 Installing and removing system components