Dell EMC E46S001, Installation And Service Manual, Page: 133 / 184

Next steps
1 Follow the procedure listed in After working inside your system .
2 Install any device drivers required for the card as described in the documentation for the card.
M.2 SSD module
Removing the M.2 SSD module
Prerequisites
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in Before working inside your system .
3 Remove the air shroud .
4 If installed, remove the rear drive cage .
5 Remove the BOSS card.
NOTE: The procedure to remove the BOSS card is similar to the removing an expansion card .
Steps
1 Loosen the screw and lift the retention strap that secures the M.2 SSD module on the BOSS card.
2 Lift the M.2 SSD module and slide it out of the connector on the BOSS card.
Figure 89. Removing the M.2 SSD module
Next step
Replace the M.2 SSD module .
Installing and removing system components 133