NOTE:
To use an micro SD card with your system, ensure that the Internal SD Card Port is enabled in
.
Steps
1
Locate the micro SD card connector on the internal dual SD module. Orient the micro SD card appropriately and insert the contact-pin
end of the card into the slot.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2
Press the card into the card slot to lock it into place.
NOTE:
Temporarily label each SD card with its corresponding slot before removal.
Next step
Follow the procedure listed in
After working inside your system
System board
Removing the system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted to create a
recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this system
board, you must supply the recovery key when you restart your system or program before you can access the encrypted data on
your drives.
CAUTION:
Do not attempt to remove the TPM plug-in module from the system board. Once the TPM plug-in module is installed,
it is cryptographically bound to that specific system board. Any attempt to remove an installed TPM plug-in module breaks the
cryptographic binding, and it cannot be re-installed or installed on another system board.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Remove the following:
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
a
b
c
d
e
f
g
h
i
j
k
l
m
rSPI card (must be migrated to new system board)
Steps
1
Disconnect all cables from the system board.
CAUTION:
Take care not to damage the system identification button while removing the system board from the chassis.
2
Using the Hex nut driver-5 mm and Phillips #2 screwdrivers, remove the screws that secure the system board to the system.
Installing and removing system components
93
