Dell EMC E02B, Installation And Service Manual, Page: 80 / 108

Figure 37. Installing the M.2 SSD module
1 module connector (2) 2 screws (2)
3 modules (2)
Next steps
1 Install the BOSS card .
NOTE: Installing the BOSS card is similar to installing the expansion card riser.
2 Install the air shroud .
3 Follow the procedure listed in After working inside your system .
Network Daughter Card
Removing the Network Daughter Card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in Before working inside your system .
3 Remove the PCIe mezzanine card .
Steps
1 Using the Phillips #2 screwdriver, remove the two screws that secure the Network Daughter Card (NDC) to the system board.
CAUTION: To prevent damage to the NDC, you must hold the card only by its edges.
2 Lift the card from the system board.
80 Installing and removing system components