Dell EMC 6WDJR, Installation And Service Manual

Page: 71 / 129

Storage controller card
Removing the PERC card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in the Before working inside your system .
3 Remove the expansion card riser .
Steps
1 Remove the screw securing the blue release latch.
2 Rotate the blue release latch to disengage it from the PERC card.
3 Push the blue release latch until the tab on the latch clicks into the slot on the chassis.
4 Hold the PERC card by the edges and pull it to disconnect it from the connector on the system board.
5 Flip the PERC card and disconnect the cable from the PERC card.
Figure 45. Removing the PERC card
Next step
1 Replace the PERC card .
Installing the PERC card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in the Before working inside your system .
3 Remove the expansion card riser .
Installing and removing system components 71