•Plug the SensorVac into a USB port or use supplied battery pack.
•Remove cover from battery pack and insert batteries as shown inside
battery pack.
Getting started
Step 1: Set up your camera to be cleaned
Refer to the Appendix of this guide for step by step instructions on
putting your camera into sensor-cleaning mode.
If you don’t see your camera in the appendix go to
www.delkin.com/clean or refer to your camera’s manual.
Caution:
Review your camera’s manual for any cautionary notes.
Please follow any and all instruction for sensor cleaning as stated in
the camera’s manual.
Step 2: Inspect with SensorScope
Start by removing the end caps from the
SensorScope. Hold the camera in one hand and hold
the SensorScope up to the camera’s lens mount
area. Please note that the SensorScope is not made
to attach to the camera like a lens and it will fi t on
the lens mount differently for each camera. Turn
on the SensorScope by pressing the power button
located on the top side of the battery compartment.
Battery Pack
8
Summary of Contents for DigitalDuster
Page 1: ...C L E A N I N G G U I D E ...
Page 29: ......
